Re: The shop is moving!
 

Probably when the snow melts enough so I can get it out of storage.

Re: The shop is moving!
 

Sounds good.

Re: The shop is moving!
 

1G AWD SS strut tower bar with integral firewall mount
http://www.dsmtuners.com/forums/hand...html#post73783
http://www.dsmtuners.com/forums/atta...1-7-2gfstb.jpg

Re: The shop is moving!
 

That could be very doable. I am not real crazy about that design, but it is a good starting point. Hopefully I have the rest of the cement floor poured in the shop by the end of the month.

Re: The shop is moving!
 

Hey Jet, would you have any way of getting a non-running car up to your place to make the exhaust?

Re: The shop is moving!
 

I have a car trailer and truck. The shop isn't done yet though, so I won't be able to do anything for a while.

Re: The shop is moving!
 

The new shop floor is being poured on Monday! The fun part will be moving the TIG, press and compressor down to the shop.

Re: The shop is moving!
 

I don't need the exhaust anymore, but one of those strut tower bars would be pretty sweet :)

Re: The shop is moving!
 

The shop floor is in! Next I need to get tile board on the walls over the concrete forms (that is why the walls look so dirty).

http://i264.photobucket.com/albums/i...mn/Shop003.jpg

http://i264.photobucket.com/albums/i...mn/Shop002.jpg

http://i264.photobucket.com/albums/i...mn/Shop001.jpg

Re: The shop is moving!
 

Those walls remind me of some basement from a horror flick where people get tortured and killed. Haha

Re: The shop is moving!
 

Looks good. A few good coats of paint will take care of most of that; how the fuck did it get so dirt though? Looks there was a demo durby going on down there.

Hey Jet, how long until you outgrow this shop? I say 6 months....ha ha.

Re: The shop is moving!
 

Those aren't walls like you normally think of, they are the outside of the cement forms. The walls are poured concrete, not block. The stuff is like styrofoam and they get dirty while the walls are being poured. The guy that had the house earlier also grew weed in that room :D

I plan on building an accessory building in the next year or 2 also. That one will have high enough ceilings for a lift or 2. I am limited to 720 sqft on that one.

Re: The shop is moving!
 

looks good did you continue the heated floors under the new part also

Re: The shop is moving!
 

Yes, the heated floors were already done, they just didn't pour the slab for some reason. I need to rip down those cheesy shelves and get the wall board up, then it is time to start moving stuff in. It is bigger than what the pic's look like too. It is 36'x28' (980 sqft).

Re: The shop is moving!
 

nice. he wanted the dirt floor with the warm water running throught it so he could grow his weed with out to much extra heaters probley

Re: The shop is moving!
 

Looks good man! Can't wait until the house is done and we can play poker in the secret weed cave!

Re: The shop is moving!
 

Looks good ICF walls with heated floors should be nice and energy efficent. What kind of insulation doese it have in the ceiling?

Re: The shop is moving!
 

I would like to see this place too, looks sweet.
Also someone i was talking to earlier brought up the idea of a heater that burned old oil, then i thought what about a heated floor that burns old oil.