View Single Post
Old 11-20-2005   #5
Halon
Pewp Champion
 
Halon's Avatar
 

Join Date: Nov 2003
Location: Blaine
Drives: Teh Bean
Posts: 12,309
Send a message via AIM to Halon
Re: 1Gb rear conversion

Well so far what i did is just remove the litte bulb wiring harnesses off the both sets of tails, and attached the 91 bulbs and plugs onto the 92 tails. Looks like it will work fine. All I'll have to do is take off that extra bulb socket off the 92 harness, and run some wires over to the other blinker bulb wiring. But now I ran into another problem. The little socket dealy for the blinker on the far corner of the tails, well apparently they were a different design, becuase it will not plug in. CVD, can I gank these 2 sockets off your car? It's just that one socket the bulb plug into, the ones that go into the very ends/corners of the rear tail lights.

Edit -Here is a pic that shows the piece I need. I need the grey/black plug connector dealy that the bulb plugs into and goes into that hole. Anyone have them? CVD are they still on your car?
Attached Images
File Type: jpg piece needed.jpg (31.6 KB, 941 views)
__________________
B-Man - FlexFuel Mafia
1991 TSi AWD E85 - BEP S362, DSMLink V2, Built 2.0L Idle Vid 628hp Graph 541hp Vid 10.93@137 Vid
1992 SC300 E85 - BW 84-75, Vlad Infinity, NA-T, 6spd Idle Vid 709hp Graph 709hp Vid 11.1@131 Vid
2006 Bayliner 195 - Carbed 5.0 Top Speed Test

Last edited by Halon; 11-20-2005 at 03:43 PM..
Halon is offline   Reply With Quote