MitsuStyle - View Single Post

blageo23 · 04-18-2007

All you have to do to install the rear is put some bolt in(holes already there) and bolt it up.

As for the motor. Im not sure if im going to have it dowled yet. probably tho.

The wiring in mostly finished just have to wait to get the engine in to route all the wires where they need to go. The tin snips were for the fuel lines(hard lines) I had to cut them off to get them all the way out.

Im hoping to get this out and running by FOR SURE the end of May. Hopefully ALOT sooner!

04-18-2007	#11
blageo23 AWD4G64 Join Date: Jun 2004 Location: Shoreview, MN Posts: 2,286	Re: Project Fast Spyder All you have to do to install the rear is put some bolt in(holes already there) and bolt it up. As for the motor. Im not sure if im going to have it dowled yet. probably tho. The wiring in mostly finished just have to wait to get the engine in to route all the wires where they need to go. The tin snips were for the fuel lines(hard lines) I had to cut them off to get them all the way out. Im hoping to get this out and running by FOR SURE the end of May. Hopefully ALOT sooner!