MitsuStyle - View Single Post

**asshanson** · 02-07-2008

You could also disconnect the flapper arm from the actuator, that would force the flapper open 100% of the time. I accidentally did this once and I could only get 8 or 9 lbs of boost by redline on my internally gated 20g.

Someone correct me if I'm wrong, but if it still goes over 20lbs then it's insane boost creep, right? And if boost stays low then the actuator isn't opening the flapper properly?

02-07-2008	#18
asshanson immune from paybans Join Date: Oct 2005 Location: West Des Moines Drives: poorly Posts: 4,358	Re: mbc wont work You could also disconnect the flapper arm from the actuator, that would force the flapper open 100% of the time. I accidentally did this once and I could only get 8 or 9 lbs of boost by redline on my internally gated 20g. Someone correct me if I'm wrong, but if it still goes over 20lbs then it's insane boost creep, right? And if boost stays low then the actuator isn't opening the flapper properly?