MitsuStyle - View Single Post

**asshanson** · 02-13-2008

Every time I try to work on my car or upgrade it, I get a huge wrench into the situation and nothing goes as planned. I attempted to put on the 61 last night, then realized that the motor mount was right where the IC piping needed to go to the passenger side. Suck.

So I realized I need to have the piping route to the drivers side like everyone else with big turbos, but both endtanks on my greddy FMIC point to the passenger side. So today I ordered a Spearco 2-216 setup with 2.5" short route piping on ebay, $400 shipped. The core is 28x10x3.5.

Hopefully I can sell my entire Greddy FMIC and 2.25" piping setup for not a big loss. Still sucks though, I have to wait another week to have a working car.

02-13-2008	#150
asshanson immune from paybans Join Date: Oct 2005 Location: West Des Moines Drives: poorly Posts: 4,358	Re: Make slowboy not so slow Every time I try to work on my car or upgrade it, I get a huge wrench into the situation and nothing goes as planned. I attempted to put on the 61 last night, then realized that the motor mount was right where the IC piping needed to go to the passenger side. Suck. So I realized I need to have the piping route to the drivers side like everyone else with big turbos, but both endtanks on my greddy FMIC point to the passenger side. So today I ordered a Spearco 2-216 setup with 2.5" short route piping on ebay, $400 shipped. The core is 28x10x3.5. Hopefully I can sell my entire Greddy FMIC and 2.25" piping setup for not a big loss. Still sucks though, I have to wait another week to have a working car.