MitsuStyle - View Single Post

xveganxcowboyx · 07-14-2008

I have the stage 4 kit, but had them substitute the stage 3 disk (only difference is it's sprung). I have somewhere around 15k on it. So far it's held well, though I haven't pushed it anywhere near it's limits. I had it out recently and noticed some grooves worn in the fingers of the pressure plate. The friction surface may be a little more worn than I'd like, but that was just me eyeballing it. Didn't measure or anything.

FYI, I was running with my tranny loose from the block for a little while (I was unaware) and the clutch put up with that abuse.It's possible that explains the unusual finger wear.

07-14-2008	#4
xveganxcowboyx Wanker Join Date: Nov 2005 Location: St Paul, MN Drives: 95 M3 Posts: 1,027	Re: XTD Stage 4 clutch (opinions needed) I have the stage 4 kit, but had them substitute the stage 3 disk (only difference is it's sprung). I have somewhere around 15k on it. So far it's held well, though I haven't pushed it anywhere near it's limits. I had it out recently and noticed some grooves worn in the fingers of the pressure plate. The friction surface may be a little more worn than I'd like, but that was just me eyeballing it. Didn't measure or anything. FYI, I was running with my tranny loose from the block for a little while (I was unaware) and the clutch put up with that abuse.It's possible that explains the unusual finger wear.