MitsuStyle - View Single Post - 1G extrude honed intake, any info/opinions?

**scheides** · 11-23-2008

Yup, $200 and under (excluding core) would probably be worth it. R&R'ing IM is a PITA though, just be ready for your chest and back to hurt. I just did a basic ported manifold on my evo, the runners were portmatched, and the inlet side was bored to 65mm, to exactly match the ported stock TB I had done at the same time (to 65mm). If you do this, look at doing a ported TB at the same time. Not sure what options there are for doing the ported TB on a DSM, but its worth investigating.

11-23-2008	#8
scheides flips McGee Cribbage Square Champion! Great Mahjong: Classic Champion! Mah Jongg Solitaire Champion! Mahjong Connect Champion! MuMu Champion! Join Date: May 2004 Location: Minneapolis, MN Drives: BeaterX Posts: 12,900	Re: 1G extrude honed intake, any info/opinions? Yup, $200 and under (excluding core) would probably be worth it. R&R'ing IM is a PITA though, just be ready for your chest and back to hurt. I just did a basic ported manifold on my evo, the runners were portmatched, and the inlet side was bored to 65mm, to exactly match the ported stock TB I had done at the same time (to 65mm). If you do this, look at doing a ported TB at the same time. Not sure what options there are for doing the ported TB on a DSM, but its worth investigating.