That wasn't directed at you so much.
But either way, I'm not going to replace rings on a motor with what I consider good compression. My numbers have always seemed a little lower than what others show. I have a feeling my tester just reads a little low.
Last time the head was done up in Andover at a place called Northern Cylinder Head. Real nice guy, he's done a lot of little side things for me, and did a bit of work on my roommates rotary. Always had great results with them, but this one job I wasn't too impressed.
I like the finish that my uncle put on it now though, a lot nicer. Plus I got the nephew discount