View Single Post
Old 01-10-2010   #22
Halon
Pewp Champion
 
Halon's Avatar
 

Join Date: Nov 2003
Location: Blaine
Drives: Teh Bean
Posts: 12,309
Send a message via AIM to Halon
Re: Upgrading from NGK BPR9ES from BPR6ES.

Quote:
Originally Posted by blackrosenova400 View Post
Well your post there scared me a little so I went and did my own test. I pulled the injector harness off of number 4 cylinder and then pulled the spark plug. I then attached the plug back onto the wire and grounded the plug, and stuck the plug in front of my windshield so I can watch.

Fired the car and the spark almost looked like a flame. So it looked pretty powerful. Well as it was running the spark plug slipped down the windshield and into the engine bay a bit, my ground clip fell off my plug and it started arcing against my hood! It must have been a good 1/2 to 3/4 of an inch and it looked just like those globe things you touch the outside of and the the arc moves towards your hand. It then kinda fell down below the intake, I tried to grab it carfully, well it gave me a couple of good shocks, lol. Im gonna have to say mines working
Good to hear! Maybe some day we could meet up and swap units to see if mine just sucks
__________________
B-Man - FlexFuel Mafia
1991 TSi AWD E85 - BEP S362, DSMLink V2, Built 2.0L Idle Vid 628hp Graph 541hp Vid 10.93@137 Vid
1992 SC300 E85 - BW 84-75, Vlad Infinity, NA-T, 6spd Idle Vid 709hp Graph 709hp Vid 11.1@131 Vid
2006 Bayliner 195 - Carbed 5.0 Top Speed Test
Halon is offline   Reply With Quote