MitsuStyle - View Single Post

**asshanson** · 01-24-2010

There was just a thread on where to get ARP moly lube, go to DB, it's close to MG.
Unless you're just talking about assembly lube, then any oreillys should have that.

edit: I'd also consider buying a new rod at that point. Why mess around with gouged parts that you had to file down to fit right, especially on a part like that. Plus the rod bolt bent? Sounds like it's pretty messed up.

01-24-2010	#38
asshanson immune from paybans Join Date: Oct 2005 Location: West Des Moines Drives: poorly Posts: 4,358	Re: Im a dsmer again! There was just a thread on where to get ARP moly lube, go to DB, it's close to MG. Unless you're just talking about assembly lube, then any oreillys should have that. edit: I'd also consider buying a new rod at that point. Why mess around with gouged parts that you had to file down to fit right, especially on a part like that. Plus the rod bolt bent? Sounds like it's pretty messed up. Last edited by asshanson; 01-24-2010 at 02:57 PM..