View Single Post
Old 06-30-2010   #22
C89ZX7R
 
C89ZX7R's Avatar
 

Join Date: May 2010
Location: Richmond Va
Drives: 87 and 89 Chrysler Conquest
Posts: 134
Re: Rebuilding the 87 Conquest TSI

Started the car and turned it around......Still needs some tlc.....


Installed the gas tank, changed the fill tube to tank rubber hose and added a anti-roll over vent. Anti-roll over vent has to be installed to vent the tank when you remove the charcol canister. Gas tank caps only allow to vent "IN" not "Out", the valve will go both ways but will close when liquid or alot of pressure hits it. The top left hose is the vent line, it wraps around and that little white ring near the zip tie is a fuel filter. Then it goes to up and sits above the gas tank lid, see next picture.



Because I didn't want excessive fumes building up in the fender I added another hose which takes all the fumes and liquid if any to the ground behind the rear tire.

__________________
Motor Is Tight, Sounds Unbelievably Badass, Intimidates Slow Hondas Instantly
C89ZX7R is offline   Reply With Quote