[Pushit2.0]

Here is the after math of the fire.






The fire started around the starter in the main harness.



Here is what was left that is still good.



Here is all the stuff I had to cut out.







The clean up process, sulfur and water do not make a good mix. I still have a lot of clean up to go, but that will take place over this winter.







And the new stuff, I picked up a V2 AEM EMS. I remade the engine bay harness, and will be using the peak/hold injector drivers to run the 1600's as the primary injectors. Then over the winter I will go back to 1 fuel rail and buy some Injector Dynamics 2150's. I also made a gear/rpm/mph graph. Even though the splits look bad for 2nd/3rd the car has little to no lag between gears. I also picked up a wide band that will be wired in.

The car should be done and up at the cookout this weekend. Then its to the track to see what this car can do.

~John