[turbotalon1g]

I found this post on tuners:

Tsunari:
"For future reference, you can have the body of the NT TB where the seal goes bored .040" deeper and the turbo TB shaft seals should fit. For some reason, that recess on the NT TB is only .100" deep as compared to .140" deep on the turbo TB.

Or perhaps dig around for a seal similar to the turbo shaft seal but something not as tall

****EDIT****
1G Turbo 10mm x 14mm x 3mm

1G NT 10mm x 14mm x 2mm --- If you can't find a seal like this, bore the recess 1mm deeper (a total of 3.5 - 3.6mm) and use the Turbo seals

So i guess next step is too find someone who can bore out the part where the seals sit for me, and I'm picking up some mil.spec turbo TB seals.