Thank you very much!
More work this week, this time I've been focusing mainly on the interior. It's pretty much ready to be put back together but I'm going to wait until the engine is in for good to put the dash in. Then it's just wiring the gauges and I'll be done.
I never did get any real good pictures of the interior so I figured I post some up.
These are the front and rear Granny's torque arm mounts:
The rear mount requires trimming the carpet a little and also the center console:
Here's the center console resting in place:
I put the rear back together as well (yes that's original 22 year old carpet/panels):
One problem I noticed (after bolting the roll bar in, of course) is that I can't open up the rear bins all of the way anymore.
This isn't really a problem on the driver's side since I can still fit shit in there, but charging the battery would be a bitch. So, I removed the hinges and put velcro in place. It looks good and is super functional - and you can't even tell there's velcro there at all. I tried magnets for a super clean look but couldn't get anything to hold in place. Maybe sometime later if it ends up bugging me that much!
AGM battery solidly mounted with 3/8" diameter bolts through the floor:
