[dsmolition]

Ok good to know that it was not just me.

Originally Posted by turbotalon1g

Very pimp that you drove up, what is your setup?

I'd guess an old 61mm? or new 5858

I don’t have a built thread.

Basic run down of the dsm.
its a precision t4 6262 .58
dnp manifold
44mm tial wg

bc 280/280cams
bc springs and retainers
aem gears
head is ported.
Cometic hg with standard arp studs.

SMIM q45 90mm tb
fic bm 1450cc inj on e85. 81% injector duty cycle @ 36psi.
Twin wally 255's in tank -6an feed. to a fuel lab ss micron filter
omni4bar/gm iat
Tuned on ecmlink v3
shep trans act clutch/flywheel
off the shelf weisco/eagle bottom end 8:5:1 comp .40 over arp hardware
ETS race fmic 3.5'
ksport coils

Originally Posted by bramagedained

I forgot about that too. My dad said my car was right at 40psi when he hit it on the way home. The last time I was at MAP before this the dyno sheet had a couple more psi than what it actually was.

Should bring it to the shootout this year and get in the Q16! Car was clean man. Makes me want to sell the dsm and put the coin into my evo haha.