MitsuStyle - View Single Post

tmosser · 01-16-2013

So im figuring send block to map for either a rebuild 2.0 or a 2.3

than take my head to either one of the shops you guys are suggesting (to save $) have them tell me what it needs and buy the parts from map.

-MAP beehive springs and retainers
-re use valves (if I can)
-OEM seals
-Re use cosworth m2 (272/272) cams
-Get new MAP head studs or buy new ARP studs
-OEM gaskets

I think I am going to try one of these turbos. I've read a couple reviews on evom many good reviews on it, and I know in the srt 4 community (where I came from) these turbos are a big hit, everyone that runs it loves em so figure ill give it a shot.

http://shopping.kinugawaturbo.com/ki...300ps-4-3.aspx

Just use a turbosmart wga with it.

01-16-2013	#26
tmosser Join Date: Aug 2011 Location: St. James Drives: 06 Evo IX Posts: 130	Re: Rebuilding motor, need suggestions So im figuring send block to map for either a rebuild 2.0 or a 2.3 than take my head to either one of the shops you guys are suggesting (to save $) have them tell me what it needs and buy the parts from map. -MAP beehive springs and retainers -re use valves (if I can) -OEM seals -Re use cosworth m2 (272/272) cams -Get new MAP head studs or buy new ARP studs -OEM gaskets I think I am going to try one of these turbos. I've read a couple reviews on evom many good reviews on it, and I know in the srt 4 community (where I came from) these turbos are a big hit, everyone that runs it loves em so figure ill give it a shot. http://shopping.kinugawaturbo.com/ki...300ps-4-3.aspx Just use a turbosmart wga with it. __________________ 14 PB GSR Last edited by tmosser; 01-16-2013 at 06:40 PM..