Thread
:
beaterX project thread
View Single Post
05-16-2013
#
1378
scheides
flips McGee
Cribbage Square Champion!
Great Mahjong: Classic Champion!
Mah Jongg Solitaire Champion!
Mahjong Connect Champion!
MuMu Champion!
Join Date: May 2004
Location: Minneapolis, MN
Drives: BeaterX
Posts: 12,900
Re: beaterX project thread
Got the pistons/rods out of the old motor last night. Here's a look at the piston from cyl1:
Rings seem smooth but the crown (?) of the piston obviously has some damage around it. The marks on the piston line up with the marks on the cylinder wall, so that piece fo spark plug obviously got stuck alongside the edge of the piston/wall, did some damage and then either disintegrated or flew out the exhaust.
Little scuffing around the skirt, all cylinders have this but this one is about 10x worse than the others (due to the scraped cyl walls I'm sure):
Rod bearing on #1, a few others have small wear marks like this and the black around the one edge but for 25k miles of 550-600whp I'm thinking they are not too shabby!
Here's cyl 4 for comparison, smoove as buttah
These rods are just manly (not Manley, but MAP Ultimate Duty!):
Next to a 2G DSM rod for beef comparison. These rods are built for doing some epic power!
__________________
Quote:
Originally Posted by
Murlo26
I need to listen to Scheides more often i think :)
Quote:
Originally Posted by
turbotalon1g
...I realized that I can't keep up my shit talking without anything to back it up.
Quote:
Originally Posted by
JV
S2000: For those of us that know the Miata is the best car on the planet, but also want extra power and to not have to turn in our man cards.
Last edited by scheides; 05-16-2013 at
09:11 AM
..
scheides
View Public Profile
Send a private message to scheides
Visit scheides's homepage!
Find More Posts by scheides