Well since it's so cold and I've been so lazy lately I just thought it was time for some exercise. I hauled the block into my basement apartment from the garage to help prevent some rust. Any who, my E3 block is all ready. Bored & honed to 85.344" then had it line honed with my ARP mains.
Besides ordering pistons, rods and bearings all that's left is to tap all holes :giggity:, fix one of the transmission bolt holes, clearance for the 2.4 crank then clean up the oil pump passages. Then find out what I'm missing and buy that. lol I'll hopefully be starting a nice job in the next few weeks. I hope the weather will start cooperating so I can get some of the engine bay work done. Then work on the suspension so I can actually have this done by the end of summer!