MitsuStyle - View Single Post

mark4g63t · 08-13-2014

Fuel leak was at the rubber seal between the top of tank and the sending unit where the big white lock ring would sit. While fixing that I created a leak at the fitting for the fuel line and had to get one welded on.

From there I went full braided line from the tank to a fuelab filter (10 micron) then to the rail.

I do remember the pump sitting a little strange like it wasn't fully seated into the rubber o-ring thats on top of the pump between it and the sender but IIRC it was like this before.

Fuel pump is seeing ~13.4V after rewire.

Will check it out and make sure.

Thanks

08-13-2014	#3
mark4g63t Join Date: Jun 2012 Location: Twin Cities Drives: 95 Talon TSI Posts: 941	Re: Fuel Pressure Issue Fuel leak was at the rubber seal between the top of tank and the sending unit where the big white lock ring would sit. While fixing that I created a leak at the fitting for the fuel line and had to get one welded on. From there I went full braided line from the tank to a fuelab filter (10 micron) then to the rail. I do remember the pump sitting a little strange like it wasn't fully seated into the rubber o-ring thats on top of the pump between it and the sender but IIRC it was like this before. Fuel pump is seeing ~13.4V after rewire. Will check it out and make sure. Thanks Attached Thumbnails __________________ BW8776, e-85 Last edited by mark4g63t; 08-13-2014 at 10:04 AM..