MitsuStyle - View Single Post

Onefast99gsx · 04-18-2005

Clamps are just the cheap radiator clamps. They were like 80 cents a piece. Coupling was like $12 per foot. I know i didn't have much more than a foot into it, maybe 14" total if that. The mandrel bends were around $12-13 a piece. The straight pipe on top would probably be around $20 or so. It was scrap, i just polished it up. Ok, so maybe i had a little bit over a hundred into it. Point is, it was cheap. If you have access to a saw, TIG welder, go for it.

04-18-2005	#35
Onefast99gsx Join Date: Sep 2004 Location: Wisconsin Posts: 1,411	Re: FMIC Piping costs Clamps are just the cheap radiator clamps. They were like 80 cents a piece. Coupling was like $12 per foot. I know i didn't have much more than a foot into it, maybe 14" total if that. The mandrel bends were around $12-13 a piece. The straight pipe on top would probably be around $20 or so. It was scrap, i just polished it up. Ok, so maybe i had a little bit over a hundred into it. Point is, it was cheap. If you have access to a saw, TIG welder, go for it.