LC-1 and narrowband sim

[dsmghost]

I have a 94 talon tsi with V3 and I installed my LC-1 just like this,

Narrowband simulation install (DB gauge, Logging, ECMlink v3 setup)
[LC-1 sensor placed in front o2 spot]
Red wire – 12v accessory power source
Blue wire – chassis ground
White wire - ECU sensor ground (pin 24)
Brown – ECU pin 15
Yellow – DB gauge’s white wire
Black – Calibration push button to monitoring LED to ground

I enabled narrowband sim using the front o2 spot and chose LC-1 wideband, did the free air calibration, and reprogrammed analog out 1 values to match analog out 2 values. My gauge reads what seems to be correct, but on v3 its logging a constant 7.5:1, How do I log what my gauge reads?