What really pissed me off I tryed to fit them and found out that the centering ring was way to small for a dsm/evo hub. So me and my dad made a tool out of a 2 5/8 alum hole saw and a pvc pipe adaptor that fit in to the center ring hole on the rim to cut them out to make them the right size. After 2 hours of cutting all 4 are done and will be out for powder tomorrow now.
here is the pics of what we did to the rims
the stock size hole 56.1 mm

cutting to the new size total 67.1 mm

one fully cut it is just the back side of the rim does not go all the way through the rim

the tool

after the 4th rim the pvc broke

what was cut out of them and my front h&r spacer we used to check the rims to make sure they were cut deep enuf
