MitsuStyle MitsuStyle
 

Go Back   MitsuStyle > Tech > Turbo / Engine / Drivetrain
Reload this Page big bore kit for 420a

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 11-19-2006   #10
rst95eclipse
 
Alias 3 Champion! Ass Hunter Champion! Basil Brush Gobbler Champion! Basketball Shoot-out Champion! Battle Snake Champion! Blasterman Champion! Bloody Rage Champion! Brave The Bar Champion! Bubble Bobble Champion! Bubble Bobble The Rival Champion! Car Park Chaos Champion! DTunnel Champion! Hexxagon Champion! Mario Kart Extreme! Champion! PacMan Jungle Adventure Champion! Pacmania 3 Champion! Q*Bert 2004 Champion!
Tournaments Won: 7

Join Date: Feb 2006
Location: Minneapols/Rochester, MN
Posts: 734
Re: big bore kit for 420a
How is it easier to work on a 4g63 compared to a 420a? My RS was much more friendly when wrenching on it. My advice to you would be to build the bottom end. There is no way that you'll be able to keep up with a GST with a 16g. Plus you can run something a bit bigger. Only rods and pistons with some clevite bearings and you're in bidness.
Last edited by rst95eclipse; 11-19-2006 at 10:22 PM..
rst95eclipse is offline  
 

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:50 AM.

Contact Us - MitsuStyle.com - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
vBulletin 3.5 Skin by ForumTemplates.com