took the engine harness out so I can take it all apart and shorten up wires and reloom the full thing and get it tucked. Also got the engine bay harness out so I can get the other one that I took all the extra wiring out of that was not needed. One of the nuts came off the front bumper bracket and had to cut a hole in the frame rail to get the bumper off the car.
started on the right side of the engine bay. Took out the cusco brake stop bracket,brake booster,clutch master,line and slave.
Then I went after the body glue with the torch and then the wire wheel to get the car ready to seam weld the car to make it stiffer. Also wire wheeled all the bolt holes that are not need on the frame rail.
got all the bolt holes welded shut just have to go after them with the flapper disk to make them look better.
Also got the full right side seam welded up
just have to seam weld the left side,weld the bolt holes on the left side. Also have to weld the the bolt holes on the fire wall shut
Threaded Mode