Quote:
Originally Posted by slowbubblecar
Using 2 nuts works just as well if there is room. Tighten the two together and start backing out the inside nut (closer to the head). Since it doesn't have anywhere to go, it will turn the whole stud. I would try to drill it so you can remove the manifold and try this way if there is room. The vise grip method is a pain on your hands and might be harder to do with such a short stud.
|
Yea but you cannot use 2 nuts to fix this fiasco. Could weld a nut onto the mess and try backing it out.
Threaded Mode