Mark's Evo IX MR Winter Projects

[Pushit2.0]

http://www.solarflux.com/Pages/Productinfo.html

For SS welding I used this, its a powder you mix with methanol and put on the back side of each weld with a little brush. You mix it to a not to think, not to thin paste and after your parts are all mocked up I mark and break it all down to put the flux in.

It leaves a black glassy backing where the weld is, then wash out your pipes when you are done. Looking good, this should move out when your done.

[Mark Leasure]

Quick update: I fab’d up my merge collector this weekend. I’m still waiting on the v-band to finish it up. I plan on assembling my engine next week. I’m still waiting for the transfer case to come back from jacks before I can get the engine back in the car. I have a couple of weeks off at the end of the month and I plan on wrapping up the motor/trans/t case installation, with a stretch goal of finishing my manifold fabrication then too!!
I bought one of those gas saver lenses and another argon regulator for back purging. I haven’t welded much stainless in the past so for a first try I think it turned out awesome.