Big Brown's Automagic - The last episode in my DSM story.

[turbotalon1g]

I ohm'd out the 1G connector to the ECU and all wires were 0.7 to 1.0 ohms, apart from the MPI control relay that goes to MPI relay pin 7 that came to 144.5 ohms.

I tested my "jumper" harness and that ohm'd out fine 0.7ish it's about 6" long and I have had it for 4 years.

---------- Post added 10-02-2013 at 22:29 ----------

I tried out a local's ECU and still the same thing, I tried my ECU in his car and he said it was acting normal.

Big thanks to Steve Hill/Goodbye always helping me out.

---------- Post added 10-02-2013 at 22:30 ----------

Thanks to Wade I was able to figure out 100% my cable was bad.

Oh on a side note, my new DSMLink cable works like it should.