The shop is moving! - Page 2

Kevin 1G Drummer · 12-22-2007

Probably when the snow melts enough so I can get it out of storage.

**JET** · 12-22-2007

Sounds good.

Jakey · 01-03-2008

1G AWD SS strut tower bar with integral firewall mount
http://www.dsmtuners.com/forums/hand...html#post73783

**JET** · 01-03-2008

That could be very doable. I am not real crazy about that design, but it is a good starting point. Hopefully I have the rest of the cement floor poured in the shop by the end of the month.

**Halon** · 01-04-2008

Hey Jet, would you have any way of getting a non-running car up to your place to make the exhaust?

**JET** · 01-05-2008

I have a car trailer and truck. The shop isn't done yet though, so I won't be able to do anything for a while.

**JET** · 02-15-2008

The new shop floor is being poured on Monday! The fun part will be moving the TIG, press and compressor down to the shop.

Kevin 1G Drummer · 02-15-2008

I don't need the exhaust anymore, but one of those strut tower bars would be pretty sweet

**JET** · 02-19-2008

The shop floor is in! Next I need to get tile board on the walls over the concrete forms (that is why the walls look so dirty).

Kevin 1G Drummer · 02-19-2008

Those walls remind me of some basement from a horror flick where people get tortured and killed. Haha

TheBlizzard · 02-20-2008

Looks good. A few good coats of paint will take care of most of that; how the fuck did it get so dirt though? Looks there was a demo durby going on down there.

Hey Jet, how long until you outgrow this shop? I say 6 months....ha ha.

**JET** · 02-20-2008

Those aren't walls like you normally think of, they are the outside of the cement forms. The walls are poured concrete, not block. The stuff is like styrofoam and they get dirty while the walls are being poured. The guy that had the house earlier also grew weed in that room

I plan on building an accessory building in the next year or 2 also. That one will have high enough ceilings for a lift or 2. I am limited to 720 sqft on that one.

TkrPerformance · 02-20-2008

looks good did you continue the heated floors under the new part also

**JET** · 02-20-2008

Yes, the heated floors were already done, they just didn't pour the slab for some reason. I need to rip down those cheesy shelves and get the wall board up, then it is time to start moving stuff in. It is bigger than what the pic's look like too. It is 36'x28' (980 sqft).

TkrPerformance · 02-20-2008

nice. he wanted the dirt floor with the warm water running throught it so he could grow his weed with out to much extra heaters probley

**Halon** · 02-20-2008

Looks good man! Can't wait until the house is done and we can play poker in the secret weed cave!

carltalon · 02-23-2008

Looks good ICF walls with heated floors should be nice and energy efficent. What kind of insulation doese it have in the ceiling?

turbotalon1g · 02-23-2008

I would like to see this place too, looks sweet.
Also someone i was talking to earlier brought up the idea of a heater that burned old oil, then i thought what about a heated floor that burns old oil.