WTB: 6 bolt long block

[C3L1CA]

Looking to buy a 6 bolt long block.

It can be built, stock, assembled, taken apart, whatever as long as all the major pieces are there.

Let me know what you have and what you want for it.

[C3L1CA]

bumpity

I'll even take suggestions on where to look for a cheap long block.

[GREASEMONKEY]

I have a built longblock for sale. All the parts on or in the motor are brand new,I Also have receipts for everything.

Here are some specs:

2.0L 6 Bolt, Block was hot tanked, Bored & Line honed. It has new oil squirters, and ARP main studs.

The crank was micro polished & the oiling holes were recessed
ACL race series main & rod bearings
Manley Rods
Mahle 7.5:1 Pistons (.040 Over)
Arp L19 headstuds
Mitsu MLS HG
New Mitsu front case & BSE
Power Enterprises Kevlar TB

*The Head is also built, All the work was done by D&G Motors in St. Louis Park. It has the following Done to it:

6 HRS of port and polish work
5 Angle valve job
Ferrea Comp valves I / E, Intake valves are 1mm Over
3G Lifters
Webcam dual titanium springs & retainers
Crower 414 cams (280's)
AEM adjustable timing gears (RED)
Shaved and polished VC


IM sure im forgetting a couple of things, If you want more info or a price feel free to PM me or give me a call @ 651-366-8682.

I will be parting out my whole setup, So if you want any other parts check out the thread..

-Stephan