Bent valves? or Droped a valve, Pictures inside!

[Super Bleeder!!]

Originally Posted by 1999Gst

okay cool i think i'm going to pull the head today or wensday, i'll post some pics. What should i do for a head gasket and studs? kinda off topic but i have a 16g and wanna run e85 and go around 350

stock head bolts and the factory organic gasket will do you just fine.

[sleepydsm]

Originally Posted by Super Bleeder!!

stock head bolts and the factory organic gasket will do you just fine.

Aren't new headbolts kinda pricey?

[Super Bleeder!!]

Originally Posted by sleepydsm

Aren't new headbolts kinda pricey?

I didn't think they were torque to yield bolts? I would reuse them on a mild setup.

[Pushit2.0]

The 6 bolt head bolts are not TTY, so if the threads look good put some oil on the threads and under the bolt head and fallow the factory torque down method. Or a set of ARP head studs is around $100 new. If you go the ARP route I recommend torquing them to 100ft/lbs with the moly lube. And if you use a composite gasket to put copper spray on it.

~John

[1999Gst]

Yea i had a 6 bolt lined up but that fell through, so a Yeai'm a go mls and get some arps and post some pics of my little rebuild in the project fourm.