Opinions on a head gasket.

[Kevin 1G Drummer]

My immediate choices are between a Mitsu Composite, and a Mitsu Multi layer. I've heard good things about the composite gaskets with ARP's, so I was considering that. And I know the Multi layer is capable of holding more boost, but you need to have perfect sealing surfaces on the head and block.

So my question is which would you reccomend, and why?

[Supa_dupa_man]

Cometic... because thats what I have... I had the Mitsu MLS (multi layer steel) on my 6bolt, and I never popped it while running some serious boost... if you use the MLS, make sure you use anarobic sealant on the gasket... It makes the seal better...

[JET]

Don't get a cometic, especially the mls, they are junk. The HP is alright.

Anyway, we need some more info. How much boost are you running, what HP are you going for and what turbo is it?

More than likely you will be fine with just a stock gasket. I have run the cometic mls, hp and stock. I am now back to the stock gasket (with copper spray) and haven't had any problems at 32 psi on a good sized turbo. After the stock gasket I would go to the Felpro mls gasket, it is the new hotness.

[scheides]

He's currently running ~20psi on a 3076 pushing about 300whp. Kevin, I say just go with a stock gasket!

[Kracka]

+1 stock gasket

[TkrPerformance]

kevin is asking because his oem multi layer is pushing coolent and well be puting a new head gasket in this weekend

[scheides]

Try the composite then, or do an MLG and crank down the arps a tad more What were they torqued to before?

[Kevin 1G Drummer]

I think we torqued the ARP's to 90 or 95. I'm not sure.

[JET]

Stock HG with ARP's torqued to a hundo with moly lube. Copper spray both sides first and call it good.

[turbotalon1g]

Yeah stock should be fine at these levels.
Good luck this weekend.

[Kracka]

Ask Shane what he uses instead of copper spray...he mentioned something a few days ago while ranting in Brownman's thread.