How many T's can you make in a vacum line?
 

I have a boost a pump and already have all the vacum line ports in use.. I have my boost controller T'ed off the BOV line but was wondering if I could get a piece that looks like + and run my boost a pump off of it aswell?

Re: How many T's can you make in a vacum line?
 

I think you want to have a dedicated line for the bov.

Re: How many T's can you make in a vacum line?
 

Kinda hard to do this when you have no vacum lines.

Re: How many T's can you make in a vacum line?
 

^Then T into your line again.

Or buy a vacuum block.

Re: How many T's can you make in a vacum line?
 

Yeah, don't tee into the BOV line for a boost controller, the pressure drop when the controller valve opens can screw with normal operation.

Tee off the FPR line for the sensor like you would for a boost gauge, and give the MBC its own line as well. Not like you actually need any of that emissions crap hooked up anyway.

Re: How many T's can you make in a vacum line?
 

Boost guage is t into fpr line.

Re: How many T's can you make in a vacum line?
 

Then tee off the line for the boost gauge inside the cabin?

Less mess in the engine bay...

Re: How many T's can you make in a vacum line?
 

Get yourself a vacuum manifold, it'll make finding a vacuum source a lot less painful and it'll be cleaner.

http://www.maperformance.com/vibrant...lack-2691.html

Re: How many T's can you make in a vacum line?
 

I like this idea! Thanks!

Re: How many T's can you make in a vacum line?
 

I said the same thing!

Re: How many T's can you make in a vacum line?
 

Ok sorry, thanks aaron

Re: How many T's can you make in a vacum line?
 

Am I wrong or isn't your boost controller supposed to be connected before the throttle body like off the fitting from the turbo if equipped?

Re: How many T's can you make in a vacum line?
 

It's ideal to have it tapped in as close to the turbo as possible.

Re: How many T's can you make in a vacum line?
 

My turbo does not have a nipple off of it for the boost gauge

Re: How many T's can you make in a vacum line?
 

Ive seen it tapped and sealed into a UICP after the turbo. Just simply drilling a hole in your UICP, and putting a barbed nipple and some sealant/JB to keep things from leaking.

Re: How many T's can you make in a vacum line?
 

x2

Re: How many T's can you make in a vacum line?
 

Just make sure the BAP sensor is not on a vac line with an electronic boost controller, if you have a "standard" manual boost controller put it in line with what ever sees manifold pressure and you are good to go.

Its a dsm, put it in the crank case or water jacket and it might work just fine.

~John