Well its looking good to bringing it there but I really doubt it will run by then. Im talking with a few companies about full sponsorships to get me an engine, turbo, tranny, etc so if any of those pull through it may be running but I doubt even that. I am however pretty sure I will trailer it there just for fun.
I finished getting the body aligned with the chassis, putting on the fenders, bumpers, doors, etc. Along with all the brake componants, rear end, suspension, tires, etc... Its pretty much a full rolling chassis again.
I will get it tinned this week for sure. It may not be my final aluminum work but it will suffice for now to get it going. There are still alot of loose ends to tie up but many of them are not difficult or time consuming. I expect it to be fully finished minus the engine / transmission within a week or two at most. I should set up a donation box for an engine, transmission and turbo or something
Pics of the project will be coming up shortly here. It all turned out quite well.
Threaded Mode