My Talon

[sleepydsm]

I dropped it off at a local diesel shop. I even called a few places, pretty much everyone said I'll need a new center cartridge, if they can even ID the current one. Should be about, oh, $600... Booo.

All I know is that this is a 6-blade comp, 12 blade turbine, I got it brand new as just a HX40 for a DSM. Apprently there should be some part numbers on the back side of the compressor wheel, and they will hopefully try and match up that wheel with a new center section. I'd like to keep the 69lb/min comp wheel if possible. I won't be a stock 2.0L forever

Wheelhop do you know any part numbers for my 6 blade hx40?

Also, my turbine housing is a little messed up, guess I'll have to whip out the dremel!

Oh, and BEP housing for the lose: The bolt holes not tapped all the way through, my hardened steel turbo bolts missing 1/3 of their threads and a pain to remove.

[wheelhop]

Originally Posted by sleepydsm

Wheelhop do you know any part numbers for my 6 blade hx40?

hx40 compresso part numbers

There are VERY few hx40s out there with the 6blade wheel from the factory. They usually come with the slightly faster spooling and slightly lower flowing 10blade hx40 turbine (will bolt right into any hx40 cut turbine housing).

[sleepydsm]

Originally Posted by wheelhop

hx40 compresso part numbers

There are VERY few hx40s out there with the 6blade wheel from the factory. They usually come with the slightly faster spooling and slightly lower flowing 10blade hx40 turbine (will bolt right into any hx40 cut turbine housing).

thanks.