Coolant cap untwisting itself, why?

[turbotalon1g]

Me=dumbass, what i meant by that last question is, could i do a hg without getting the head milled/block decked?
I don't have the time since I have to leave in a week and i can basically only do it on saturday, or will it be a complete waste of time to just slap a new HG and studs in there?

I'm thinking its worth a try.

[blackrosenova400]

Get a straight edge and a feeler gauge to check the head and block when you pull the head. Id say nothing over .002 and you would probably be fine with a composite gasket.

Originally Posted by turbotalon1g

Me=dumbass, what i meant by that last question is, could i do a hg without getting the head milled/block decked?
I don't have the time since I have to leave in a week and i can basically only do it on saturday, or will it be a complete waste of time to just slap a new HG and studs in there?

I'm thinking its worth a try.