beaterX project thread

**scheides** · 07-07-2010

Check out this sweet plate that Rosey machined for me! I'm going to get it powdercoated over at primo sometime in the near future.

**goodhart** · 07-07-2010

Any before picture? I don't wanna scroll through 14 pages.

**scheides** · 07-07-2010

Quote:

Originally Posted by goodhart

Any before picture? I don't wanna scroll through 14 pages.

IDK if I have any. It was just a black piece of plastic with 3x holes like the center one. When I got the seat heater controls in there they obviously didn't fit, and a few attempts I made with bondo were nothing short of amazingly aweful. Rosey made this piece and then shaved down the entire top 1/4" of the black plastic, this fits right on top. Once its PC'd It'll get affixed to the plastic piece below with a little bit of our favorite bonding agent

Matt D. · 07-07-2010

Quote:

Originally Posted by scheides

Check out this sweet plate that Rosey machined for me! I'm going to get it powdercoated over at primo sometime in the near future.

The button on the left is crooked.