HELP.... Injector fitting question/problem

Onefast99gsx · 05-16-2005

I found this off dsmlink..... DAM!! Is this what i have to do. Not run those grommets. Instead have to grind the dam rail???

a small advice to PTE...sell injectors that fit.

Well, somewhat. They fit and all, but when i went to plug the harnesses back into them, I found out the injectors were pinned against the fuel rail little fingers that stick out next to where the plugs are.

SO...off comes the fuel rail again, and to the grinding table, ground each 2 little tabs off flush, and now they fit perfectly.

Im lucky I have a grinding wheel though.

Onefast99gsx · 05-17-2005

Here is a pic of the problem. Someone out there has to know or heard of this. Basically the injector is pinned up against the rail so now i can't get the connector on. Please check out the pic.